High Voltage 1CH PWM Signal Relay Switch Navigation Light Controller for Aircraft Remote Control Relay RC Toy Description: l Small size and light weight l Adopt transparent heat-shrinkable rubber, stylish appearance, at a glance l Input channels do not need to be calibrated, compatible with various brands of remote control devices l With boot protection, easy to operate l Support 5-9v high voltage receivers. l 1 channel servo signal input, control one way electronic switch l Maximum 10A30VDC l Two LEDs indicate working status l Increased no signal protection Application range: l Remote control model rocket launch l Remote control model smoke control l Weapon system control like real machine l Model aircraft's smoke control l Control of various remote switch systems l Switch the signals of two cameras l Control the opening and closing of various electrical power sources, such as navigation lights, searchlights, strobe lights, buzzers, etc. l Control the camera shutter or switch the camera's recording and camera mode. Functional Description: l The remote switch remotely controls the electrical equipment on the aircraft model through a switch channel on the remote control, and the 1-way LED dynamically demonstrates the current switch state in real time, so it can be quickly started without an operation manual. l This device does not require calibration and can be accurately compatible with remote control devices of various brands. Typical application: 1. Connect l Plug the signal input cable into an idle receiver channel (recommended for the two-stage switch channel), which corresponds to a switch on the remote control. l The red indicator light will be illuminated when connected to the receiver. l The blue work indicator lights up when the switch channel is open, and vice versa. 2. Working mode l The red LED is always on; the signal is normal. The red LED light flashes; no signal. l The blue LED indicates the relay's operating status. 3. Trigger l Turn the switch on the remote control (OFF->ON), the blue LED lights up and the relay starts to work. l Turn the switch on the remote control off (ON-> OFF), the blue LED will go out and the relay will not work. Package: 1x K1 Relay Switch