1Safe Performance: The rectification and braking circuit part uses integrated module design, the heat dissipation and reliability make the performance of the entire system to be safe. 2Sealed and Waterproof Design: Adopt sealing waterproof design, do not have to worry about the controller is burned after the short circuit, the protection level is IP67, can be used in the air humidity, salinity, stagnant water, etc. 3Good Heat Dissipation: The outer shell is made of anti corrosion aluminum, and the multi edges floor design increases the heat dissipation area, so that the controller can better dissipate heat. 4Can charge the Battery: The wind turbine can be controlled to charge the battery, when the battery is full, the wind turbine will brake, and when the voltage drops to the recovery voltage, the charge will be resumed. 5Multiple Protection: With multiple protections such as waterproof, strong wind, anti reverse connection, and temperature compensation, etc. 6Wide Applications: Mainly used for wind power generation systems, wind and solar hybrid power generation systems, etc., for engineering or household use. Item Type: Wind Turbine Generator Controller Product Model: FW10-24 Rated Battery Voltage: 24V Wind Generator Rated Power: 1000W Wind Generator Braking Voltage: 30V Wind Generator Recover Voltage: 27V Quiescent Current: 15mA Protection Level: IP67 Working Temperature: -35-+75 Shell Size: Approx. 150 x 132 x 48mm / 5.9 x 5.2 x 1.9in 1 x WindGenerator Controller1. Confirm that the output voltage of the wind turbine is consistent with the rated voltage of the battery.2. Connect according to the wiring diagram, first connect the positive and negative poles of the battery, and then connect the 3 phase voltage output of the wind turbine.3. Please carefully follow the user manual to connect the battery and wind generator to the controller. If you do not connect the battery and the wind generator as required, the reverse polarity or the wrong position will cause damage to the system components.4. It is strictly forbidden to connect the controller directly to the wind generator before connecting the battery