Please note: this light control can not be directly connected to the battery, nor does it support the high-voltage receiver.Just plug the steering gear plug of the remote control panel into the third channel of the receiver, and you can remote control the light switch through the third channel of the remote control.1#: Single circuit and high current version are pure switches, without explosion flash breathing lamp.2#: Single channel and double channel lamp control are used to receive power supply output 5v1a, output 1a, and connect other equipment within the allowable range of voltage and current.4#: The high current version is independent power supply, with input voltage of 5v-24v, current of 5A and instantaneous current of 10A. Output 5A3#: Four channel lamp control is independent power supply, input voltage is 5v-24v, single group current is not more than 3a.1#: Single channel light control: every time the third channel switch is toggled or the third channel button is pressed, the output turns on - > off - > on - > off... Cycle2#: Two way light control: two output are always on at the same time - > a output is on, B output is off - > a output is off, B output is on - > two output alternate burst - > two output are burst at the same time - > two output breathing light effect - > two output are all off... Cycle4#: High current independent power supply: every time the third channel switch is turned or the third channel button is pressed, the output will turn on - > off - > on - > off... Cycle3#: Four way light control: running light mode - > four way burst in sequence - > one three, two four way alternate burst - > four way simultaneous burst - > four way full light - > four way breathing light effect - > one three way light - > two four way light - > one four way light - > two three three way light - > three four way light - > one four way light - > two way light - > three four way light -