Platform Cable USB, Programmer & Debugger for Xilinx Devices USB compatible cable for in-circuit configuration and programming of all Xilinx devices Overview The Platform Cable USB a USB compatible cable for in-circuit configuration and programming of all Xilinx devices. It is compatible with the original XILINX Platform Cable USB. Features - Performance 1. Using CY7C68013A+FPGA solution, fully compatible with the original XILINX Platform Cable USB 2. Programs all Xilinx devices, including FPGAs CPLDs ISP Configuration PROMs 3. Supports JTAG, Slave-Serial and SPI programming, to config all Xilinx devices 4. Interfaces to devices operating at 5V 3.3V 2.5V 1.8V 1.5V 5. Optional target clock frequency, supports XILINX software automatic frequency adjustment 6. Firmware auto upgrade, its possible to support more new released software and devices 7. Anti-static and multi-layers signal isolation, to protect the target and the programmer itself - Supported software 1. Xilinx ISE 2. iMPACT 3. ChipScope 4. Vivado - Supported devices 1. Xilinx FPGA devices: UltraScale 7 series Zynq Kintex Virtex Artix Spartan, etc. 2. Xilinx CPLD devices: XC9500 XC9500XL XC9500XV CoolRunner XPLA3 CoolRunner-II, etc. 3. Xilinx PROM devices: Platform Flash XCF00S XCF00P XL, etc. LED Status 1. Red: USB connected 2. Yellow: USB connected, and Vref (the target board) is powered How to Connect 1. Connects to PC: Via USB interface 2. Connects to target board: Platform Cable USB provides 3 different interfaces to connect with the target board: JTAG, Slave Serial, and SPI. The figure below shows the header pinouts of the interfaces: Package contents 1. Platform Cable USB main unit x1 2. JTAG adapter x1 3. USB cable x1 4. 8-pin header to 7-pin separated cable x1 5. 8-pin header to 6-pin header cable x1 6. 14-pin (2.54mm pitch) JTAG cable x1 7. 14-pin (2mm pitch) JT