For Renault Immobilizer Emulator is used to decode the ECU; no PIN code is required. Only 3 wires to connect: Ignition, Ground, and Data. The emulator module is capable of emulating an immobilizer data stream to the ECU. Compatible with Renault models fitted with single-data-wire coded immobilizers, approximately from 1994 until the introduction of CAN (2001 to 2003, depending on model). Features: - IMMO PIN code not required - Decode the ECU using the Renault ECU decoder - Only 3 wires to connect: Ignition, Ground, and Data - Small module size - Designed to be permanently connected to the vehicle - Non-volatile memory ensures no data loss, even after battery disconnection or jump starts - Module can be reused if necessary The emulator module emulates an immobilizer data stream to the ECU each time the ignition is turned on, allowing the vehicle to start using a standard steel (non-electronic) key. Supported Petrol ECUs: - Magneti Marelli IAW 06R - Bosch Motronic MP7.0 - Sagem Safir2 (35pin) - Sagem Safir (55pin) - Siemens Sirius32 - Siemens Fenix5 - Siemens Fenix3B - Magneti Marelli IAW 8R.30 Supported Diesel ECUs: - Lucas DCU3R (1.9D) - Bosch EDC15C3 (DCI) - Bosch MSA15.5 (DTI) - Coded fuel cut-off valve (1.9D DDS)