FV-200Hz5V frequency is 0-5V voltage voltage module DAC module Features:1. Convert 0-200Hz frequency pulse signal to 0-5V analog voltage signal.2. It can be used to convert the interface between PLC and frequency or motion control card and the occasion of controlling the matching of the converter interface.3. The input pulse level is 5V 12V 24V can be directly inputted, without string resistor. However, the frequency of the input signal should be maintained for more than 0.5 seconds.4. The output current is 5MA.5. Frequency and voltage conversion module, the response time is about 0.3-0.5 seconds. Specification:Condition: Item Type: Frequency to Voltage Conversion Module Model: FV-200Hz5V Feature: 0-200Hz input frequency is converted to 0-5V Output Source: 5MACresponse Rate: 0.3-0.5 seconds Size: Approx. 4.5x4.7x1.7cm/1.8x1.9 x 0.7in Package List:1 x Frequency to Voltage Conversion Module Precautions for Use:1. A multiturn potentiometer on the board is used to calibrate the proper relationship between frequency and voltage.2. The input voltage range of the power supply is 12-30vdc. It is recommended that the supply voltage should be 15-24VDC. When the 12V level is used, the power supply cannot be powered by 12VDC. A minimum of 15VDC power supply is required. If you want to use a 12V power supply, you can also order a 12VDC. Solar powered converter. At 24 levels, the power supply must be powered by 24VDC3. The signal input is isolated by the diaphragm. Guaranteed anti-interference capability.4. For use with PLC, it supports NPN type. It must have a ground wire.5. If you want to use the encoder, the encoder should be rotated to a constant speed for more than 0.5 seconds.6. Frequency and voltage conversion module, the response time is about 0.3-0.5 seconds.7. If the signal input is turbine flow, etc., due to signal matching, 817 diaphragm and resistor should be added to match the flow meter with the normal function.8. When using correspondence, if there is deviation, you can adjust the blue potentiometer on the board to adjust. At the time of shipment, we adjusted the F/V potentiometer for the specific correspondence. It is generally not recommended to adjust it yourself. Identification and wiring:1. 12-30V-positive power input2. GND-Negative Power Input (Common Ground Wire)3. GND-Pulse Frequency Input Negative (Common Ground Wire)4. 0-10KHZ-Pulse Frequency Input Positive5. GND-Pulse Frequency Input Negative (Common Ground Wire)6.0-10V-Analog Level Output 0-10V Correspondence and Line Relation:20Hz is converted to 0.5V100Hz is converted to 2.5V200Hz is converted to 5V