PROGRAM A SINGLE BUTTON REMOTE CONTROL 1. Press and release the Learn button for the selected channel on the receiver. The corresponding LED will glow steadily for 30 seconds. 2. Within 30 seconds, press and hold the button on the remote control that you wish to program to the receiver. 3. Release the remote control button when the LED on the receiver blinks, then turns off. Programming is complete. Repeat the steps above for each remote control you would like to program. Color: As Shown Material: Plastic PROGRAM A 3-BUTTON REMOTE CONTROL AS OPEN, CLOSE, AND STOP 1. Press and release the CH1 Learn button on the receiver. 2. Within 30 seconds, press the desired OPEN button on the remote control. 3. Press and release the CH2 Learn button on the receiver. 4. Within 30 seconds, press the desired CLOSE button on the remote control. 5. Press and release the CH3 Learn button on the receiver. 6. Within 30 seconds, press the desired STOP button on the remote control. NOTE: If a remote control button is not pressed within 30 seconds, the LED next to the selected Learn button will turn OFF. In that case, repeat the programming. TO ERASE THE MEMORY: Press and hold the Learn button for the channel you want to erase. Release the button when the corresponding LED turns off; the memory has been erased. Package Contents: 1 x Receiver Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture to be slightly different from the real thing. The measurement allowed error is +/- 1-3 cm.