Item Type: DC Motor Speed Controller_x000D_ Input Voltage: DC10-55V (the specific voltage must be equal to the rated voltage of the motor)_x000D_ Output Voltage: Linear under load_x000D_ Instantaneous Current: 60A _x000D_ Continuous Current: 40A_x000D_ Speed Regulation Type: Current Regulation_x000D_ Speed Adjustment Method: Jog + -_x000D_ Timing: Yes_x000D_ Limit Function: Yes_x000D_ Slow Run Slow Stop: Can be set_x000D_ Speed Digital Display: 0-100 percentage_x000D_ Speed Range: 0-100%_x000D_ Control Frequency: 15KHZ_x000D_ Connection Type: Fence type terminal_x000D_ Support Motor: Brush Motor_x000D_ Module Size: 148x95x36mm / 5.83x3.74x1.42in_x000D_ Mounting Size: 142x88mm / 5.59x3.46in_x000D_ Installation Method: Embedded_x000D_ _x000D_ Function:_x000D_ 0-1-2-3-4-5-6-7-8-9 function settings are as follows:_x000D_ Manual Automatic Mode Selection Function 0: 1 is manual mode, 2 is automatic mode, default is manual mode._x000D_ Slow Run Time Setting Function 1: 000-100, slow start to 100% speed, adjustable time 0-10s, default is 1s._x000D_ Slow Run Time Setting Function 2: 000-100, slow stop, adjustable time 0-10s, default is 1s._x000D_ Speed Lower Limit Setting Function 3: 000-080, adjustable minimum speed 0-80% and less than the maximum speed setting value, default is 0._x000D_ Speed Upper Limit Setting Function 4: 000-100, adjustable maximum speed 0-100% and greater than the minimum speed setting value, default is 100%._x000D_ Acceleration/Deceleration Value Setting Function 5: 001 002 005 010 015 020 025, each time the key increase/reduce is pressed, the speed changes by 1%, 2%, 5%, 10%, 15%, 20%, 25%._x000D_ Motor Running Time Setting Function 6: 1s to 99h 59min 59s, default is 99h 59min 59s._x000D_ The following functions 7-8-9 are time setting in automatic mode_x000D_ Forward Rotation Time Setting Function 7: 0s-99h, default is 10s_x000D_ Stop Time Setting Function 8: 0s-99h, default is 10s_x000D_ Reverse Rotation Time Setting Function 9: 0s-99h, default is 10s_x000D_ Limit Mode Selection Function E:_x000D_ E1: No limit, default is no limit_x000D_ E2: After pressing start, the motor rotates forward to the forward limit and stops. After pressing start again, the motor rotated reverse_x000D_ E3: After pressing start, the motor rotates forward to the forward limit, and then rotates reverse to the reverse limit, finally motor stops_x000D_ E4: After pressing start, the motor rotates forward to the forward limit, and then rotates reverse, cycle working