The PDB-XT60 has been engineered to provide the highest possible performance and reliability in a 36 x 50mm & 4 layers PCB. It distributes power from a LiPo pack to 6 ESCs, as well as providing synchronised & regulated DC 5V outputs & linear regulated DC 12V for powering Cameras, Servos, RC receiver, Flight Controllers, Video Transmitters, LEDs, etc. It offers a XT60 socket to connect the LiPo pack conveniently. color: Black Material: PCB Description: General: Input voltage range (3S-4S LiPo operation): 9 - 18V DC Regulated 5V and 12V outputs LED power indicators ( 5V & 12V outputs ) 6 ESC outputs & 1 pair VCC/GND pads ESC outputs: Continuous current: 25A x 4 or 15A x 6 Peak current (10 seconds/minute): 30A x 4 or 20A x 6 BEC 5V output: Designed for RC Receivers, Flight controllers, OSD, and Servos. DC/DC synchronous buck regulator. Voltage: 5.0 +/- 0.1VDC Continuous current: 2 Amps (Max.2.5A 10s/minute) Output Ripple: 40mV (VIn=16V, VOut=5V@2A load) Short-circuit tolerant (5 seconds/minute) BEC 12V output: Designed for Video TX or FPV camera with linear regulator. The battery should be 4S LiPo (13~18V DC) Voltage: 12.0 +/- 0.3VDC Continuous current: 500mA (Max.0.8A 5s/minute) Short-circuit tolerant (2 seconds/minute) BEC 12V @ 3S LiPo Output voltage= 3S LiPo voltage -1V Features: 2oz copper, 4-layers &1.6mm PCB. Built-in XT60 Socket Total 6 pairs ESC solder tabs are fit for H or X type frame 5V & 12V Output LED indicators & Short circuit tolerant The appearance, color, and printing of the product may vary from batch to batch, but this does not affect use. Package Contents: 2 x Power Distribution Board