2670 Brushless Electronic Speed Controller 2-6slipo Power Supply 70a Suitable For Multi-axis Uavs

Adopting 32-bit high performance processor STM32G071, the working frequency is up to 64MHz, and it supports up to 128KHz motor PWM frequency.PCB adopts 8 layers of 3OZ immersion gold process, high power MOS combined with metal heat sink, high current load can also be effective heat dissipation, continuous and stable work.Support motor unidirectional, bidirectional, with brake and other motion modes. Support low voltage protection, temperature protection, blocking protection, current protection and other multiple protection.The ESC automatically detects the throttle signal when it is powered on, supports all signals, and at the same time supports signal protocols such as PWM, Oneshot and Multishot.Widely used in multi-axis drones, fixed-wing aeromodels, model boats, climbing cars, model cars and other scenarios.Model Name : SQESC 2670Processor : STM32G071Input Voltage : DC 7V-25.2V (2-6S Lipo)Continuous current (good heat dissipation) : 70AMaximum current (good heat dissipation): 110ASupported firmware : BLHeli_32BLHeli_32 Firmware: SEQURE_G071_01AM32 Firmware: SEQURE_G071Signal protocol: (all), PWM, Oneshot, Multishot, etc.Programming: SupportThrottle Calibration : SupportAngle Setting : SupportCurrent Detection : SupportTelemetry Signal: SupportMotor Steering Setting :SupportRGB LED color light : SupportApplication Scenario: Multi-axis drone, fixed-wing aerial model, model boat, climbing car, model car, etc.Depending on the batch, the appearance and color of the product , but this does not affect use.Colour:Photo ColorMaterial:plastic+metalPackage Contents:1 x Motherboard1 x 14awg 100mm black silicone wire1 x 14awg 100mm red silicone wire1 x 35V 680UF high frequency capacitor2 x 18 specifications heat shrinkable tube 50mm2 x 18 gauge heat shrink tube 28mmOnly the above package content, other products are not included.Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.