Cutting in metal in a sustainable way, a solid frame and an alternative model of opening made of metal. Heating block, heating within 1 minute, the highest temperature is 2000 ℃. liandgt; The cutting surface is clean, the cutting speed is high, and the service life is very long. liandgt; An additional blade is supplied that is made of materials andamp; 8209 that are not brittle, small and easy to use. liandgt; A wide range of applications, mainly in cutting trademarks from fabrics, rubber bands, lace, cutting edges and gluing trademarks, etc. liandgt; Before production, the blade must be tested pod heat angle, so some blades will show traces of rust, ale will not affect the use. Please think twice. liandgt; - Inner mesh panties Article type: Hot cutting machineliandgt; Automation degree: manualliandgt; Drive form: electricliandgt; Total blade length: approx. 8,1 cm / 3,2 inchliandgt; Effective hot cutting width: approx. 6,5 cm / 2,6 inchliandgt; Blade statement: Before production, the blade must be tested pod for heat, so some blades will be used or traces of rust, ale will not affect the use. Please think twice. liandgt; Power switch: thermostat knobliandgt; List of packages: 1 x hot cutting machine 1 x bladeliandgt; Please note if you need a plug adapterliandgt; When replacing the blade, make sure you use a blade with the specified specification, otherwise the mismatch will affect the life of the machine, and even ona may be damaged! liandgt; If there are foreign objects in the contact part of the blade or in the hole of the upper blade screw in the machine, they should be cleaned and then tightened with 4 screws. Try not to touch copper conductors and screw holes on both ends of the blade with your hands, so as not to stick foreign bodies and affect the conduction of electricity. liandgt; When replacing the blade, loosen the pod the fan counterclockwise, and then unscrew the 4 screws that attach the blade. liandgt; After replacing the blade, turn the screw clockwise until the blade is straightened to avoid thermal bending of the blade. liandgt;