1. Since the module design does not require a common ground at the beginning, it is not possible to add a diode on the board tube, and the output capacitor to prevent damage caused by transient overvoltage, so the user When in use, there may be instantaneous high-voltage pulses, or the use voltage is close to In the case of 35V, it is recommended to add diodes and The output capacitor protects the module. 2. The voltage drop of the module is about 0.3V when the module is unloaded or the load current is extremely small. When the load current When it is 10ma (12V voltage test), the voltage drop will drop significantly and is related to the current small related. Operating voltage:1.5V-36V Working current: 12V 25 without cooling measures less than equal 15A (15A long-distance running test for 30 minutes) 12V 25 heat sink + air cooling less than equal 30A (30A long-distance running test for 30 minutes) If the theoretical heat dissipation is good, it can be above 50A, but the heat dissipation condition is limited to above 30A No long-distance running test Static current: 0ma (no load state, there will still be current when the load is in sleep state) Positioning method:welding fixed Since the module does not need to be grounded, it is superior to modules that need to be grounded. The potential is obvious, it can be directly connected into the circuit like a diode, and the static working voltage The flow is 0, but there are also disadvantages. If your product is sensitive to the following sense, then it is to this module, It is sensitive to the fluctuation of the output voltage. When the module is working, there is a certain The time voltage drop is above 0.3V. Note:Due to different production batches, the inkjet codes on the products are random and cannot be specified. Colour:AsShown Material:Plastic Package Contents: 5 * Ideal Diode Module Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.