Product condition: 100% brand new Product material: LED and ABS plastic Color: blue, green, orange, red and white Quantity: one piece Easy to install, including installation instructions. Equipment: For HONDA ST 1300 Pan European (2002-2007) For HONDA CB400 (2001-2005) For HONDA CB400SF (1999-2005) For HONDA CB600F (2003-2006) For HONDA CB600S (2000-2002) For HONDA CB900F Hornet ( 2002-2008) For HONDA CB1100SF (1999-2004) For HONDA CB1300SF (1998-2002) For HONDA CBF500 (2004-2008) For HONDA CBF600 (2004-2007) For HONDA CbR150 (2015 Modify Plug) For HONDA CBR250R (2011- 2014) For HONDA CBR600F Hornet (1995-2010) For HONDA CBR600F3 (1995-1998) For HONDA CBR600F4 (1999-2000) For HONDA CBR600F4i (2001-2006) For HONDA CBR600FS (2001-2003) For HONDA CBR9 00RR (1994-2003 ) For HONDA CBR919RR (1996-1999) For HONDA CBR929RR (2000-2001) For HONDA CBR954RR (2002-2003) For HONDA CBR1100XX (1996-2008) For HONDA 599 Hornet (2003-2006) For HONDA 919 Hornet (2002 -2008 ) For HONDA X 4 (1997-2003) For HONDA X 11 (1999-2004) For HONDA XL 1000V (1999-2002) For HONDA (1994-1997) For HONDA VFR 800 (1998-2005) For HONDA VTX 1300 (2003-2011) For HONDA VT125C Shadow (1999-2009) For HONDA VT 750S (2010-2014) For HONDA VTR1000 SP1/SP2 (2000- 2006) For HONDA VTR1000F FireStorm/SuperHawk (1997-2005) For HONDA Valkyrie Rune (2004-2006) For HONDA RVT1000RR RC51 (2000-2006) For HONDA GL 1800 Gold Wing (2001-2004) For HONDA NRX 1800 (2004- 2006 ) (If you encounter any questions, please contact me first, please do not leave negative comments first, I hope to answer your questions, thank you) - Product installation and setting methods. You need to configure this module after installation. Only do setup when the engine is warm so that the idle speed is normal, find a long, straight road with light traffic. The unit does not learn the same hardware twice, it makes it easy to set up on the road. If necessary, you can even swipe the wd oacute;ł and pause during setup. Don't stare at the display, watch the road and drive with the utmost care as always! -Turn on the ignition. It will count backwards (6 to 1), which means the memory is clear. -When "L" is flashing, keep your eyes on the engine in neutral and allow the engine to idle. -Display will flash "1". Select first gear, release the clutch and keep the engine speed above idle. The display flashes faster while the device learns the hardware. -When display shows "2", select two-position. -Repeat this process until all runs have been thought of (5 or 6). -The unit is programmed and should indicate the gears correctly. -Now when the ignition is turned on, it will display forward (1 to 6), indicating that it is fully functional. Product installation instructions and photos: Locate the connector under the fuel tank or under the seat. The green cable connects to the motorcycle crankshaft sensor cable. If you have any questions, please feel free to contact me. Thank you